Vw Navigation Rns 310 Cd Download

Tag Archives: VW RNS 310. Porsche DVD GPS 2018-2019 6.5.1 PCM3.1 EUROPE NAVIGATION. Map Update for PCM 3.1 Navigation – The latest 2018/2019 EUROPE Update. Volkswagen Manuals; Car Navigation system; RNS 310; Volkswagen RNS 310 Manuals Manuals and User Guides for Volkswagen RNS 310. We have 1 Volkswagen RNS 310 manual available for free PDF download: User Manual. Vw Navigation Rns 310 Cd Download 8GB Navigation SD Card 2018 for RNS 310 3 GB free for MP3 music As of 2013, the updates for this system are not available on CD anymore, but only on SD card Compatibility Compatibel with Volkswagen Navigation FX or RNS 310 systems.

General Information

'RNS 310' Radio/Navigation System

Note

• The part number for the radio/navigation is on a label located on the radio/navigation housing.
• Always deactivate the anti-theft coding if replacing the radio/navigation. Give the new code number to the customer.
• If the anti-theft code is not known, you can retrieve it via the known systems. You need the identification number of the radio navigation system for retrieval. It is on a sticker attached to the side of the radio. The identification number is also stamped in the material in the side of the radio navigation system.
• If a radio navigation system from one vehicle is to be installed in another vehicle, then always make sure that radio navigation systems of both vehicles have the same part number. Otherwise navigation system will malfunction since the setting of the rotation angle sensor in radio navigation system does not match the vehicle.

Note

• Familiarity with the function and operation of the digital sound system is needed if there are customer concerns.
• Refer to the Owner's Manual and → No.397 for additional information.
• Anti-theft coding is equipped with protection code number, deactivating electronic anti-theft system.
• Use the Vehicle Diagnostic Tester'Guided Fault Finding', when servicing or fault finding.
• For proper function of the navigation system, rotation angle sensor in unit must be set corresponding to installation position of unit in the vehicle. Therefore, always note the replacement part number when replacing the unit. An incorrect installation causes malfunctions in the navigation system.
• When the battery is reconnected, check any affected system or component (radio, clock, comfort electrical connection etc.) according to the repair manual and/or the Owner's Manual.

The 'RNS 310' unifies the functions of a navigation system with those of a high-value RDS vehicle radio.

In the radio navigation system double DIN housing, there are:

• A RDS radio receiver part
• Monochrome display
• A navigation system with GPS satellite receiver as well as
• A CD drive for the audio and navigation system

A connection for an external audio source is integrated into the front side of the unit.

The 'RNS 310' radio navigation system has four speaker outputs.

The CD drive can read the navigation CD-ROM or also play an audio CD. Navigation operation is only available on a limited basis when an audio CD is playing.

Note

• In addition to standard audio CDs, CDs with music files in 'MP3' format can also be played. Refer to the 'RNS 310'. Refer to the Owner's Manual.
• Music CDs with 8 cm diameter (mini-discs) cannot be played back.
• CDs with computer files on them cannot be played.

There are connections for a CD changer and a telephone system to expand the functions.

The antenna is installed in rear side windows. The antenna system does have the 'diversity function'.

The navigation antenna is a roof antenna.

Overview - 'RNS 310' Radio Navigation System

1. External Multimedia Device Interface -R215-
   • Located inside the center armrest storage compartment
   • Additional information.
   • Optional installation of 'CD changer' or 'external multimedia device interface'. The two systems cannot be installed together because the installation location is the same for both.
2. Telephone/Navigation System/Parking Heater Antenna -R66-
   • Located on the roof at the back of the vehicle
   • Installed only if, in addition to the radio, a telephone or auxiliary heater is installed at the factory
   • For more information regarding the different antenna systems.
3. Rear Window Antenna 1 -R130-
4. Right Rear Treble Speaker -R16- and Left Rear Treble Speaker -R14-
   • Installed inside the left and right side trim panels in the passenger compartment
   • For more information regarding the different speaker systems.
5. Right Rear Bass Speaker -R17- and Left Rear Bass Speaker -R15-
   • Installed inside the left and right side trim panels in the passenger compartment
   • For more information regarding the different speaker systems.
6. Amplifier -R12-
   • Installed under the left front seat
   • For more information regarding the amplifier.
7. Right Front Bass Speaker -R23- and Left Front Bass Speaker -R21-
   • Installed inside the left and right doors
   • Midrange frequencies play through the bass and treble speakers.
   • For more information regarding the different speaker systems.
8. Right Front Treble Speaker -R22- and Left Front Treble Speaker -R20-
   • Installed inside the left and right doors
   • For more information regarding the different speaker systems.
9. Left Multifunction Buttons on Steering Wheel -E440- and Right Multifunction Buttons on Steering Wheel -E441-
   • For more information regarding the multifunction steering wheel.
10. Radio/Navigation Display Unit Control Module -J503-
    • Removing and installing.
    • Connector overview.
    • Anti-theft coding.
11. CD Changer -R41-
    • 6 disc CD changer
    • Located inside the center armrest storage compartment
    • For more information regarding the CD changer.
    • Optional installation of 'CD changer' or 'external multimedia device interface-'. The two systems cannot be installed together because the installation location is the same for both.

Overview - 'RNS 310' Radio Navigation System Connector

1. Multi-Pin Connector 1, 8-Pin
   • Terminal assignment.
2. Multi-Pin Connector 2, 8-Pin
   • Terminal assignment.
3. Multi-Pin Connector 3, 12-Pin
   • Terminal assignment.
4. Multi-Pin Connector 4, 12-Pin
   • Terminal assignment.
5. Connector 5
   • Navigation antenna connection
   • Terminal assignment.
6. Connector 6
   • Radio reception antenna connection
   • Terminal assignment.

6. Connector 7
   • Radio reception antenna connection
   • Terminal assignment.

8-pin Multi-Pin Connector 1, for Speaker Outputs

1. Right Rear Speaker, Positive
2. Right Front Speaker, Positive
3. Left Front Speaker, Positive
4. Left Rear Speaker, Positive
5. Right Rear Speaker, Negative
6. Right Front Speaker, Negative
7. Left Front Speaker, Negative
8. Left Rear Speaker, Negative

8-Pin Multi-Pin Connector 2, for the Power Supply and CAN-Bus

9. CAN Bus High
10. CAN Bus Low
11. Supply Voltage Supply, Positive, Switched
12. Power Supply, Negative, Terminal 31
13. Display High Speed CAN Bus, Negative
14. Display High Speed CAN Bus, Positive
15. Voltage Supply, Positive, Terminal 30
16. Control Signal for the Anti-Theft Coding, SAFE

12-Pin Multi-Pin Connector 3, Telephone Signals

1. Microphone Input, Negative
2. AUX Out, Audio Right, Positive
3. AUX Out, Audio, Ground
4. Microphone Output, Negative
5. Left Telephone Audio Input Signal, Negative
6. Right Telephone Audio Input Signal, Negative
7. Microphone Input, Positive
8. AUX Out, Audio Left, Negative
9. Microphone Output, Positive
10. Telephone Mute (Radio Mute)
11. Left Telephone Audio Input Signal, Positive
12. Right Telephone Audio Input Signal, Positive

12-Pin Multi-Pin Connector 4, for CD Changer Controls and the CD Audio Input Signals

1. Left Input AUX Signals
2. AUX Signal Ground
3. CD Changer, Audio Signal Ground
4. CD Changer, Voltage Supply, Positive, Terminal 30, Contact Continuous Power Handling Greater Than 1A, Short-Term Peak Power Handling 5A
5. Not Assigned
6. CD Changer, DATA OUT (Data Exchange for CD Changer Control from the Radio Navigation System to the CD Changer)
7. Right Input AUX Signals
8. CD Changer, Audio Left Channel, CD/LA
9. CD Changer, Audio Right Channel, CD/R
10. CD changer, Control Wire, Switched Positive
11. CD Changer, DATA IN (Data Exchange for the CD Changer Control from the CD Changer to the Radio Navigation System)
12. CD Changer, CLOCK (Internal Test Protocol for Monitoring Data Flow)

Antenna Connections, Connectors 5, 6 and 7

Vw Rns 310

1. Terminal Connector Antenna Radio Reception AM and FM, Double Fakra, No Coding, Impedance 50 Ohm, Color Cream White
2. Terminal Connector Antenna Radio Reception FM2, Double Fakra, Coding B, Impedance 50 Ohm, Color Cream White
3. Terminal Connector Antenna Navigation (GPS), Fakra, Coding C, Impedance 50 Ohm, Color Signal Blue

Anti-Theft Code

General Information

Radio navigation system 'RNS 310' is equipped with an electronic comfort anti-theft system which operates in conjunction with the instrument cluster.

After disconnecting the power supply, the radio navigation system is ready to be used again once the power supply is connected. The anti-theft code does not need to be entered again. The anti-theft coding must be activated for the first time and the radio navigation system must be connected in the same vehicle.

Reactivating a locked radio/navigation system is only possible by entering correct radio code number for anti-theft protection.

Use the Vehicle Diagnostic Tester to get the anti-theft code. The radio card and the label on the radio that were used in the past are no longer used.

Note

The Vehicle Diagnostic Tester must be 'online' (connected to the network) in order to get the anti-theft code and the user must be authorized to access radio codes.

Anti-Theft Code, Deactivating

Special tools and workshop equipment required

• Vehicle Diagnostic Tester
• Vehicle Diagnosis System - Updated Cable - 3m -VAS5051/5a- or Vehicle Diagnosis System - Diagnostic Cable -VAS5051/6a- or Vehicle Diagnostic Tester - Diagnostic Cable - 5m -VAS5052/3-

Retrieving the Anti-Theft System Code Using the VAS Tester:

Select 'Guided Functions' or 'Guided Fault Finding' on the Vehicle Diagnostic Tester.

After all control modules have been checked:

• Press the 'GO TO' button.
• Select 'Functions/Component selection'.
• Select 'Body'.
• Select 'Electrical Equipment'.
• Select '01-OBD-capable system'.
• Select 'Radio navigation system'.
• Select 'Functions'
• Select and start 'radio code inquiry'.

Authorization will be requested from the system: Then the operating data, the VIN and the radio serial number of the radio and radio/navigation system will be automatically read out.

Note

When installing new radio / radio-navigation unit, or a unit which has not be adapted to the vehicle, it can happen that tester will not be able to read the serial number of the radio / radio-navigation unit. In this case, enter the serial number manually. The serial number can be found on a sticker on the unit and is also stamped into the side of the unit.

Then the anti-theft code will be displayed in the tester.

The radio navigation system anti-theft code must not be entered manually.

Deactivating the Anti-Theft Coding

• Switch on radio navigation system.
• Enter the anti-theft code appearing in the display in the 'RNS 310' number block and confirm it.

Unit is enabled and ready for operation.

Note

If the anti-theft code has been entered incorrectly, it can be corrected immediately in another attempt. If anti-theft code is entered incorrectly twice, then the radio navigation system is locked for an hour. Leave radio navigation system and ignition switched on. The remaining running time appears in the radio navigation system display. After one hour, then the procedure for deactivating the anti-theft system can be repeated. Remember that you always have two attempts to enter the code. After that, the radio navigation system will be locked up for one hour.

Vw Navigation Rns 310 Cd Download Windows 10

Vw Navigation Rns 310 Cd Download Full

See More:

Vw Navigation Rns 310 Cd Download Software

Volkswagen Tiguan Owners Manual > Cup holders: Cup holders in the rear center armrest
Fig. 122 In the rear center armrest: Cup holders. Read and follow the introductory information and safety information first⇒Introduction to the subject In order to use the cup holder in the rear center armrest, the padded armrest must be pulled off ⇒ Sitting properly and safely . W ...